| DTC 2-3: | Short to Another Wire or Decreased Resistance in Front Passenger's Airbag Inflator |
Special Tools Required
SRS inflator simulator ( 07SAZ-TB4011A)
| 1. | Erase the DTC memory. |
| 2. | Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off. Does the SRS indicator stay on? YES - Go to 3. NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. |
| 3. | Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes. |
| 4. | Disconnect the P1o connector from the P1i connector (A).
|
| 5. | Connect the special tool (2 W connector) to the P1i connector (A). |
| 6. | Reconnect the battery negative cable. |
| 7. | Erase the DTC memory. |
| 8. | Read the DTC. Is DTC 2-3 indicated? YES - Go to 9. NO - Short in the front passenger's airbag inflator; replace the front passenger's airbag.n |
| 9. | Disconnect the battery negative cable, and wait for 3 minutes. |
| 10. | Disconnect the U1o connector (A) from the SRS unit.
|
| 11. | Disconnect the SRS inflator simulator (special tool) from the SRS simulator lead C. |
| 12. | Install the special tool (070AZ-SAA0100) to No. 9 and No. 10 terminals of the U1o connector. |
| 13. | Check resistance between the A and B terminals of the SRS simulator lead C (special tool). There should be 1 MW or more.
Is the resistance as specified? YES - Replace the SRS unit.n NO - Replace the dashboard wire harness.n |