| 1. | Disconnect the battery negative cable, and wait at least 3 minutes before beginning work. |
| 2. | Disconnect the driver's and front passenger's airbag connectors. |
| 3. | Disconnect the side airbag connectors. |
| 4. | Disconnect both seat belt tensioner connectors. |
| 5. | Remove the center console. |
| 6. | Pull down the carpet, then disconnect the connectors and remove the two Torx bolts (A), then pull out the SRS unit (B) from the right side.
|
| 1. | Install the new SRS unit (A) with Torx bolts (B), then connect the connectors (C) to the SRS unit; push it into position until it clicks. NOTE: When tightening the Torx bolts to the specified torque after replacement, be careful to turn them in so that their heads rest squarely on the brackets.
|
| 2. | Reinstall the center console. |
| 3. | Reconnect the driver's and front passenger's airbag connectors. |
| 4. | Reconnect the side airbag connectors. |
| 5. | Reconnect both seat belt tensioner connectors. |
| 6. | Reconnect the battery negative cable. |
| 7. | Initialize the OPDS unit. |
| 8. | After installing the SRS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off. |