Center Console Removal/Installation
Center Console Removal/Installation
NOTE:
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to scratch the front seat, dashboard, and related parts.
1.
Remove the parking brake cover lid (A).
2.
M/T: Remove the shift knob.
3.
Remove the center console (A):
-1
Remove the screws (B), and clips (C).
-2
Lift the rear of the console up to detach the clip (D), and pull the console rearward to release the front hook (E) from the heater unit.
-3
Disconnect the cigarette lighter connector (F).
4.
Install the console in the reverse order of removal, and note these items:
Replace any damaged clips.
Make sure the wire harness is not pinched.
Set the rib (G) under the pocket onto the parking brake lever bracket (H) correctly.