|
DTC P15B8:
Starter Control System High Input
-
Turn the ignition switch to ON (II).
-
Clear the DTC with the HDS.
-
Turn the ignition switch to LOCK (0).
-
Turn the ignition switch to ON (II), and wait 5 seconds.
-
Check for Temporary DTCs or DTCs with the HDS.
|
YES
|
-
|
|
|
NO
|
-
|
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the TCM and the ECM.■
|
-
Turn the ignition switch to LOCK (0).
-
Jump the SCS line with the HDS.
-
Disconnect ECM connector A (49P).
-
Turn the ignition switch to ON (II).
-
Measure the voltage between ECM connector terminal A43 and body ground.
-
Turn the ignition switch to LOCK (0).
-
|