i-SHIFT Transmission Shift Change Actuator Replacement
NOTE: Use fender covers to avoid damaging painted surface.
Do the battery terminal disconnection procedure.
Remove the air cleaner housing.
Remove the transmission shift change actuator harness cover (A) and the harness clip (B).
Disconnect the transmission shift change actuator connectors (A). Remove the cotter pin (B) and select wire washer (C).
Disconnect the select actuator rod (D) and shift actuator rod (E) with joint covers (F) from the change lever assembly (G).
Remove the transmission shift change actuator (H), then remove the dowel pins (I) from the top of the transmission housing.
Install the transmission shift change actuator in the reverse order of removal with the new cotter pin.
NOTE:
Be careful of assemble direction of joint cover.
Application of grease is not allowed at installation to the rods.
Install the select wire washer certainly.
Do the battery terminal reconnection procedure.
Do the i-SHIFT system learning (static mode).
Test-drive the vehicle.
