CVT Input Shaft Planetary Carrier Clearance Inspection (CVT)

CVT Input Shaft Planetary Carrier Clearance Inspection

1.Measure the clearance between the 25 x 31 mm thrust shim (A) and the snap ring (B) with a feeler gauge (C), in at least three places. Use the average as the actual clearance.

STANDARD:  0.05-0.115 mm (0.018-0.030 in.) 

 

2.If the clearance is out of standard, remove the 25 x 31 mm thrust shim (A) and measure its thickness.

 

3.Select and install the new thrust shim, and secure them with the snap ring, then recheck.


THRUST SHIM, 25 x 31 mm
No. Part Number Thickness 
A 90451-P4V-000 1.05 mm (0.041 in.) 
B 90452-P4V-000 1.12 mm (0.044 in.) 
C 90453-P4V-000 1.19 mm (0.047 in.) 
D 90454-P4V-000 1.26 mm (0.050 in.) 
E 90455-P4V-000 1.33 mm (0.052 in.) 
F 90456-P4V-000 1.40 mm (0.055 in.) 
G 90457-P4V-000 1.47 mm (0.058 in.) 
H 90458-P4V-000 1.54 mm (0.061 in.) 
I 90459-P4V-000 1.61 mm (0.063 in.) 
J 90460-P4V-000 1.68 mm (0.066 in.) 
K 90461-P4V-000 1.75 mm (0.069 in.) 
L 90462-P4V-000 1.82 mm (0.072 in.) 
M 90480-P4V-000 1.085 mm (0.0427 in.) 
N 90481-P4V-000 1.155 mm (0.0454 in.) 
O 90482-P4V-000 1.225 mm (0.0482 in.) 
P 90483-P4V-000 1.295 mm (0.0510 in.) 
Q 90484-P4V-000 1.365 mm (0.0537 in.) 
R 90485-P4V-000 1.435 mm (0.0565 in.) 
S 90486-P4V-000 1.505 mm (0.0593 in.) 
T 90487-P4V-000 1.575 mm (0.0620 in.) 
U 90488-P4V-000 1.645 mm (0.0648 in.) 
V 90489-P4V-000 1.715 mm (0.0675 in.) 
W 90490-P4V-000 1.785 mm (0.0703 in.) 


4.After replacing the 25 x 31 mm thrust shim, make sure that the clearance is within the standard.

5.Verify that the snap ring outside diameter is 30.7 mm (1.21 in.) or less.