Brake pedal position switch signal
|
Brake pedal pressed, then released
|
CRUISE BRAKE SW should indicate OFF when the brake pedal is pressed and ON when the brake pedal is released.
|
-
Faulty
brake pedal position switch
-
Blown No. 24 (10 A) fuse in the under-dash fuse/relay box
-
An open in the wire between the ECM/PCM and the brake pedal position switch
-
A wire shorted to ground between the ECM/PCM and the brake pedal position switch
|
Clutch pedal position switch signal (M/T model)
|
Clutch pedal pressed, then released
|
SHIFT/CLUTCH SW should indicate OFF when the clutch pedal is pressed and ON when the clutch pedal is released.
|
-
Faulty clutch pedal position switch
-
An open in the wire between the ECM and the clutch pedal position switch
-
A wire shorted to ground between the ECM and the clutch pedal position switch
-
Poor ground G401
|
Transmission range switch signal (A/T model)
|
Shift lever in D and S
|
SHIFT/CLUTCH SW should indicate ON in P, R, and N and OFF in D and S.
|
-
Faulty
transmission range switch
-
An open in the wire between the PCM and the transmission range switch
-
A wire shorted to ground between the PCM and the transmission range switch
-
Poor ground G101
|
Set switch signal
|
Set/decel switch pressed and released
|
CRUISE CONTROL SET SW should indicate ON when the set/decel switch is pressed and OFF when the set/decel switch is released.
|
-
Faulty cruise control combination switch
-
An open in the wire between the gauge control module and the cruise control combination switch
-
A wire shorted to ground between the gauge control module and the cruise control combination switch
|
Resume switch signal
|
Resume/accel switch pressed and released
|
CRUISE CONTROL RESUME SW should indicate ON when the resume/accel switch is pressed and OFF when the resume/accel switch is released.
|
-
Faulty cruise control combination switch
-
An open in the wire between the gauge control module and the cruise control combination switch
-
A wire shorted to ground between the gauge control module and the cruise control combination switch
|
Cancel switch signal
|
Cancel switch pressed and released
|
CRUISE CONTROL CANCEL SW should indicate ON when the cancel switch is pressed and OFF when the cancel switch is released.
|
Faulty cruise control combination switch
|
Cruise control main switch signal
|
Cruise control main switch ON and OFF
|
CRUISE CONTROL MAIN SW should indicate ON when the cruise control main switch is turned ON and OFF when the cruise control main switch is turned OFF.
|
-
Faulty cruise control combination switch
-
An open in the wire between the gauge control module and the cruise control combination switch
-
A wire shorted to ground between the gauge control module and the cruise control combination switch
-
An open in the wire between the cruise control combination switch and ground
|
Cruise control indicator signal
|
Start the engine, turn the cruise control main switch on, and drive the vehicle above 40 km/h (25 mph). Set and cancel the cruise control.
|
CRUISE INDICATOR should indicate ON when the cruise control is set and OFF when the cruise control is canceled.
|
Faulty gauge control module
|