-
Remove the battery setting plate, and reposition the battery (D) away from the ECM/PCM.
NOTE: Do not disconnect the battery terminals.
-
Remove the bolts (E).
-
Disconnect ECM/PCM connectors A, B, and C, then remove the ECM/PCM (E).
NOTE: ECM/PCM connectors A, B, and C have symbols (A=□, B=△, C=○) embossed on them for identification.
-
Install a parts in the reverse order of removal.
-
Turn the ignition switch to ON (II).
NOTE: DTC P0630 ‘‘VIN Not Programmed or Mismatch'' may be stored because the VIN has not been programmed into the ECM/PCM; ignore it, and continue this procedure.
-
Manually input the VIN to the ECM/PCM with the HDS.
-
Select the IMMOBI SYSTEM with the HDS.
-
Enter the immobilizer code using the ECM/PCM replacement procedure in the HDS; it allows you to start the engine.
-
Select PGM-FI system and reset the ECM/PCM with the HDS.
-
Update the ECM/PCM if it does not have the latest software.
-
-
Do the CKP pattern learn procedure.
|
|