( TF09EABK72100090103FAAT00 )
DTC Troubleshooting: P0103 (50)
DTC P0103:
 MAF Sensor Circuit High Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.
  1. Turn the ignition switch to ON (II), and wait 2 seconds.
  1. Check the MAF SENSOR in the DATA LIST with the HDS.
Is about 202 gm/s, or 4.89 V or more indicated?
YES -
Go to Step 3 .
NO -
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the MAF sensor and the ECM/PCM.■
  1. Turn the ignition switch to LOCK (0).
  1. Jump the SCS line with the HDS.
  1. Disconnect the MAF sensor/IAT sensor 5P connector.
  1. Disconnect ECM/PCM connector B (49P).
  1. Check for continuity between MAF sensor/IAT sensor 5P connector terminal No. 4 and ECM/PCM connector terminal B33.
Is there continuity?
YES -
Go to Step 8 .
NO -
Repair open in the wire between the ECM/PCM (B33) and the MAF sensor, then go to Step 15 .
  1. Reconnect ECM/PCM connector B (49P).
  1. Connect MAF sensor/IAT sensor 5P connector terminals No. 3 and No. 4 with a jumper wire.
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0103 indicated?
YES -
Go to Step 20 .
NO -
Go to Step 13 .
  1. Turn the ignition switch to LOCK (0).
  1. Reconnect all connectors.
  1. Turn the ignition switch to ON (II).
  1. Reset the ECM/PCM with the HDS.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0103 indicated?
YES -
Check for poor connections or loose terminals at the MAF sensor/IAT sensor and the ECM/PCM, then go to Step 1 .
NO -
Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■
  1. Reconnect all connectors.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0103 indicated?
YES -
Check for poor connections or loose terminals at the MAF sensor/IAT sensor and the ECM/PCM. If the ECM/PCM was updated, substitute a known-good ECM/PCM, then recheck. If the ECM/PCM was substituted, go to Step 1 .
NO -
If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■