NOTE: Keep any grease off the brake drum and brake shoes.
-
-
Remove the rear wheel.
-
Remove the parking brake, and remove the brake drum (A) from the hub bearing unit.
NOTE:
-
If necessary, pry the parking brake lever (B) with a flat-tip screw driver (C).
-
If the brake drum stuck to the hub bearing unit. Thread two 8 x 1.25 mm bolts (D) into the brake drum to push it away from the hub bearing unit. Turn each bolt 90 degrees at a time to prevent the brake drum from binding.
-
After installation, press the brake pedal several times to make sure the brakes work and self adjust the brake shoes.
-
Install the brake drum in the reverse order of removal.
NOTE: Before installing the brake drum, clean the mating surfaces of the rear hub and the inside of the brake drum.
-
Clean the mating surfaces of the brake drum and the inside of the wheel, then install the rear wheel.
|