-
Pour genuine Honda Long Life Antifreeze/Coolant Type 2 into the radiator up to the base of the filler neck.
NOTE:
-
Always use genuine Honda Long Life Antifreeze/Coolant Type 2 (P/N OL999-9001). Using a non-Honda coolant can result in corrosion, causing the cooling system to malfunction or fail.
-
Genuine Honda Long Life Antifreeze/Coolant Type 2 is a mixture of 50 % antifreeze and 50 % water. Do not add water.
Engine Coolant Capacities (Including the coolant reservoir capacity of 0.44 L (0.116 US gal, 0.097 Imp gal)):
|
L15A7, L15A8 engine (Brazil Factory): M/T model: At Coolant Change: 4.57 L (1.207 US gal, 1.005 Imp gal)
|
After Engine Overhaul: 5.06 L (1.337 US gal, 1.113 Imp gal)
|
A/T model: At Coolant Change: 4.50 L (1.189 US gal, 0.990 Imp gal)
|
After Engine Overhaul: 4.99 L (1.318 US gal, 1.098 Imp gal)
|
L13Z1, L13Z3 engine (Brazil Factory): M/T model: At Coolant Change: 4.56 L (1.205 US gal, 1.003 Imp gal)
|
After Engine Overhaul: 5.05 L (1.334 US gal, 1.111 Imp gal)
|
A/T model: At Coolant Change: 4.49 L (1.186 US gal, 0.988 Imp gal)
|
After Engine Overhaul: 4.98 L (1.316 US gal, 1.096 Imp gal)
|
-
Loosely install the radiator cap.
-
Start the engine, and let it run until it warms up (the radiator fan comes on at least twice).
-
Turn off the engine. Check the level in the radiator and add genuine Honda Long Life Antifreeze/ Coolant Type 2, if needed.
-
Put the radiator cap on tightly, then start the engine again, and check for leaks.
-
Clean up any spilled engine coolant.
|
|