-
Disconnect the brake lines (A) from the master cylinder (B). To prevent spills, cover the hose joints with rags or shop towels.
-
Remove the master cylinder mounting nuts (C) and the washers (D).
-
Remove the master cylinder from the brake booster (E). Be careful not to bend or damage the bake lines when removing the master cylinder.
-
Remove the rod seal (F) from the master cylinder.
NOTE: During installation, set the new rod seal onto the master cylinder with its grooved side (G) toward the master cylinder.
-
Install the master cylinder in the reverse order of removal, and note these items:
-
Coat the inner bore lip and the outer circumference of the new rod seal with the silicone grease in the master cylinder set.
-
When you apply the silicone grease, make sure not to adhere to the terminal part of connectors and surrounding switches. Also do not touch the switches and the terminal part of connector by hands or glove that adheres the silicone grease.
-
-
-
Spin the wheels to check for brake drag.
|
|