-
Remove the hub bearing unit (A) from the spindle.
-
Check the hub bearing unit for damage and cracks.
-
Install the hub bearing unit in the reverse order of removal, and note these items:
-
Use new a spindle nut and hub cap during reassembly.
-
Before installing the spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake the spindle nut shoulder against the spindle.
-
Before installing the brake disc, clean the mating surfaces of the hub bearing unit and the inside of the brake disc.
-
Before installing the wheel, clean the mating surfaces of the brake disc and the inside of the wheel.
-
|
|