Special Tools Required
Ball joint remover, 28 mm
07MAC-SL00201
Do not remove the lower arm of both sides at the same time.
-
-
Remove the front wheel.
-
Remove the lock pin (A) from the lower arm ball joint, then remove the castle nut (B).
NOTE: During installation, install the lock pin as shown after tightening the new castle nut.
-
NOTE:
-
Be careful not to damage the ball joint boot when installing the remover.
-
Do not force or hammer on the lower arm, or pry between the lower arm and the knuckle. You could damage the ball joint.
|