( TF09E8UJ4612705363CKBAT01 )
Front Seat Cushion Cover/Pad Replacement - Without Seat Heater
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
  • Put on gloves to protect your hands.
  • Take care not to tear the seams or damage the seat covers.
  • Do not repair any tear or frayed spots of the seat cover.
  • When removing components, use the trim tools or equivalent.
  • RHD model is shown; LHD model is similar.
  1. From under the seat cushion, release the hook (A) from the seat cushion frame spring. Pull the cushion cover (B) back.
  1. From under driver's seat cushion, detach the wire harness clips (A) and seat belt buckle switch connector (B), then pull it to out side of the seat.
Driver's seat
  1. From under passenger's seat cushion, detach the seat belt setting switch connector (A) and seat belt buckle switch connector (B) (with seat belt reminder system).
Passenger's seat
  1. Remove the clip, then release the hook strips (A, B) from the seat cushion frame.
  1. From under seat cushion, release the hook strips (A, B) from the seat cushion frame.
  1. Remove the seat cushion cover/pad (A) from the seat frame (B).
  1. Install the cover in the reverse order of removal, and note these items:
    • To prevent wrinkles when installing a seat cushion cover, make sure the material is stretched evenly over the pad before securing the hook strips.
    • Check if the clip is damaged or stress-whitened, and if necessary, replace is with new ones.