Rear Door Glass and Regulator Replacement
NOTE:
Put on gloves to protect your hands.
Take care not to scratch the door and related parts.
RHD model is shown; LHD model is symmetrical.
Remove the these items:
Rear door glass outer weatherstrip
Rear door sash trim
Rear door panel
Detach the harness clip, then
disconnect the power door lock actuator connector.
Remove the plastic cover, as needed.
Carefully raise the glass (A) until you can see the bolts, then remove them. Remove the glass from the regulator (B), and carefully lower the glass.
NOTE: Take care not to drop the glass inside the door.
Pull the glass run channel (A) away as needed. Loosen the nut, and remove the bolt securing the rear lower channel (B).
Release the rear lower channel (A) from the glass (B).
-1.
Pull the channel forward, then remove the nut portion (C) from the door.
-2.
Twist the channel to pass it through the gap between the door panel and the rear sash.
-3.
Pull the channel up to remove it.
Carefully remove the glass (A) out through the window slot. Take care not to drop the glass inside the door.
Disconnect and detach the connector (A) from the regulator (B).
Remove the bolts, pull the regulator up to release the hooks, then remove the regulator through the hole in the door.
Apply multipurpose grease to all the sliding surfaces of the regulator (A) where shown.
Install the glass and regulator in the reverse order of removal, and note these items:
Raise and lower the glass to see if it moves freely without binding.
Make sure that there is no clearance between the glass and glass run channel when the glass is closed.
Adjust the position of the glass as necessary.
Do the power window control unit reset procedure.
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
Check for water leaks.
Test-drive and check for wind noise and rattles.
Make sure the power door locks, windows operate properly.