( TF09E8PJ34300044021KBAT00 )
Mirror Holder Replacement
NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the power mirror and related parts.
  • RHD model is shown; LHD model is symmetrical.
  1. Carefully push on the top edge of the mirror holder (A) by hand.
  1. Put a shop towel in the opening between the lower edge of the mirror holder and the mirror housing to prevent scratches, and detach the bottom hooks (B) with a flat-tip screwdriver wrapped with protective tape.
  1. Carefully pull out the bottom edge of the mirror holder (A) to separate the adhesive (B), and then release the side clips (C).
  1. Separate the mirror holder from the actuator (D) by releasing the hooks (E).
  1. If necessary, remove the skull cap (A).
    -1.
    Remove the tabs (B) from inside the mirror housing (C).
    -2.
    Release the hook (D), then remove the skull cap.
  1. Before reinstalling the mirror holder to the inner holder (A) of the actuator, check the actuator rods (B) and the actuator boots (C):
    • If a rod is out of the actuator hole, insert it securely.
    • Each rod should be covered with a boot. If not, adjust the boot into the proper position.
  1. Reattach the hooks of the mirror holder to the actuator, then position the mirror holder on the actuator. Carefully push on the hook portions of the mirror holder until the mirror holder locks into place.
  1. Check the actuator operation.