( TF09E8FJ54400020371KBAT20 )
Rear Door Glass and Regulator Replacement
NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the door and related parts.
  • LHD model is shown; RHD model is symmetrical.
  1. Remove the these items:
  1. Carefully raise the glass (A) until you can see the bolts, then remove them. Remove the glass from the regulator (B), and carefully lower the glass.
    NOTE: Take care not to drop the glass inside the door.
  1. Pull the glass run channel (A) away as needed. Loosen the nut, and remove the bolt securing the rear lower channel (B).
  1. Release the rear lower channel (A) from the glass (B).
    -1.
    Pull the channel forward, then remove the nut portion (C) from the door.
    -2.
    Twist the channel to pass it through the gap between the door panel and the rear sash.
    -3.
    Pull the channel up to remove it.
  1. Carefully remove the glass (A) out through the window slot. Take care not to drop the glass inside the door.
  1. Power window: Disconnect and detach the connector (A) from the regulator (B).
  1. Remove the bolts, pull the regulator up to release the hooks, then remove the regulator through the hole in the door.
Power window
Manual window
  1. Apply multipurpose grease to all the sliding surfaces of the regulator (A) where shown.
Power window
Manual window