NOTE: The sunshade calibration must be performed when any of the following events have occurred.
The sunshade will reverse while it is closing
-
Turn the ignition switch to ON (II).
-
Press and release the sunshade AUTO CLOSE switch.
NOTE: The sunshade will reverse and stop while closing.
-
Press and hold the sunshade CLOSE switch for more than 13 seconds.
NOTE: The sunshade moves to close position by the jog operation
*
, then stop in fully closed position.
*:
|
moves 40 mm, stops 0.4 seconds, then repeats
|
-
Release the CLOSE switch. Within 5 seconds, press and hold the CLOSE switch again.
NOTE: The sunshade moves to fully open position, then it moves to fully closed position.
-
Calibration is complete.
The sunshade will stop while it is operated
-
Turn the ignition switch to ON (II).
-
Press and release the sunshade AUTO CLOSE switch.
NOTE: The sunshade will stop while it is operated.
-
Press and hold the sunshade CLOSE switch for more than 13 seconds.
NOTE: The sunshade moves to close position by the jog operation
*
, then stop in fully closed position.
*:
|
moves 40 mm, stops 0.4 seconds, then repeats
|
-
Release the CLOSE switch. Within 5 seconds, press and hold the CLOSE switch again.
NOTE: The sunshade moves to fully open position, then it moves to fully closed position.
-
Calibration is complete.
|