Do the headlight initial position learning when any of the related parts of the headlight leveling system shown is replaced:
NOTE: The headlight initial position learning is required also when the suspension stroke sensor is reattached or the suspension stroke sensor arm is reconnected to the lower arm.
Learning Procedure
Before learning the headlights:
-
Park the vehicle on a level surface, and remove all of the baggage from the vehicle.
-
Make sure the tire pressures are correct.
-
Turn the ignition switch to LOCK (0).
-
Slide the front seats backward fully.
-
Have the driver (about 75 kg (165 lb)) or someone who weighs the same sit in the driver's seat.
-
Connect the HDS to the data link connector
-
Jump the SCS line with the HDS.
-
Turn the ignition switch to ON (II).
-
Within 5 seconds, turn the headlights (low beam) or passing switch ON and OFF three times repeatedly, and leave them on.
-
Turn the ignition switch to LOCK (0).
-
Disconnect the HDS from the data link connector.
-
Adjust the headlight aiming to conform with the applicable requirements.
|