NOTE:
-
This procedure checks the engine oil level sensor normality.
-
Do this procedure at a flat place.
-
Make sure that the customer hasn't added oil before doing this procedure.
-
Check for any oil leaks before doing this procedure.
-
Make sure the vehicle has the genuine oil level gauge.
-
Check for Temporary DTCs or DTCs with the HDS before doing this procedure. If any Temporary DTCs or DTCs are indicated, troubleshoot them first, then do this procedure.
-
Start the engine. Hold the engine speed at 3,000 rpm (min
−1
) without load (in neutral) until the radiator fan comes on.
-
Turn the ignition switch to LOCK (0), and wait 5 minutes.
-
Check the engine oil level with the oil level gauge.
-
Start the engine. Hold the engine speed at 3,000 rpm (min
−1
) without load (in neutral) until the radiator fan comes on.
-
Check for Temporary DTCs or DTCs with the HDS.
-
If there are no DTCs indicated, the engine oil level sensor is OK.
-
If any Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.
|
|