Side Impact Sensor (First) Replacement
Removal
-
-
-
Remove the center pillar lower trim:
-
Disconnect the floor wire harness 4P connector (A) from the side impact sensor (first) (B).
-
Using a TORX T30 bit, remove the TORX bolt (C), then remove the side impact sensor (first).
|
|
Installation
-
Install the side impact sensor (first) with a new TORX bolt (A), then connect the floor wire harness 4P connector (B) to the side impact sensor (first) (C).
-
-
After installing the side impact sensor (first) confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for 6 seconds and then go off.
-
Reinstall all removed parts.
|
|