-
Pivot the caliper down into position. Install the flange bolt (A), and tighten it to the specified torque while holding the caliper pin (B) with a wrench being careful not to damage the pin boot.
-
Install the brake hose mounting bolt (C).
-
Clean the mating surfaces of the brake disc and the inside of the wheel, then install the front wheels.
-
Press the brake pedal several times to make sure the brakes work.
NOTE: Engagement may require a greater pedal stroke immediately after the brake pads have been replaced as a set. Several applications of the brake pedal will restore the normal pedal stroke.
-
Add brake fluid as needed.
-
After installation, check for leaks at hose and line joints or connections, and retighten if necessary.
|
|