NOTE:
-
-
-
Without cruise control: The adjusting bolt is substituted as clutch pedal position switch B. The clutch pedal height adjustment is same procedure as with clutch pedal position switch B.
-
Remove the driver's floor mat before adjusting the clutch pedal.
-
If there is no clearance between the master cylinder piston and push rod, the release bearing will be held against the diaphragm spring, which can result in clutch slippage or other clutch problems.
-
Disconnect the clutch pedal position switch A and the clutch pedal position switch B connectors.
-
Loosen the clutch pedal position switch B locknut (A), and back off the clutch pedal position switch B until it no longer touches the clutch pedal (C).
-
Loosen the clutch pushrod locknut (D), and turn the pushrod (E) in or out to get the specified height (F), and the stroke (G) at the clutch pedal.
F
|
Clutch Pedal Height:
|
|
LHD model:
|
150 mm (5.91 in.)
|
|
RHD model:
|
145 mm (5.71 in.)
|
G
|
Clutch Pedal Stroke:
|
|
120−130 mm (4.72−5.12 in.)
|
|
|