( TF09E6EE34116317041KBAT00 )
Clutch Pedal Assembly Replacement

NOTE:
  • Without cruise control: The adjusting bolt is substituted as clutch pedal position switch B.
  • The illustrations show RHD model.
  1. Remove the driver's dashboard under cover .
  1. Disconnect the clutch pedal position switch A and the clutch pedal position switch B connectors (C).
  1. Pry out the lock pin (D), and pull the pedal pin (E) out of the yoke.
  1. Remove the master cylinder mounting nuts (F) and the clutch pedal mounting nuts (G).
  1. Remove the clutch pedal assembly (H).
  1. Remove clutch pedal position switch A and clutch pedal position switch B.

  1. Loosely install clutch pedal position switch A and clutch pedal position switch B.

  1. Install the clutch pedal assembly (A).
  1. Install the clutch pedal mounting nuts (B) and master cylinder mounting nuts (C).
  1. Apply multipurpose grease to the pedal pin (D), and slide it into the yoke, then install a lock pin (E).
  1. NOTE: Connect the switch connectors after adjusting them.
  1. Check the clutch operation.