M/T Mainshaft Disassembly
Special Tools Required
Bearing separator set
07631-0010000
-
Remove the angular ball bearing (A) using bearing separator set (B).
-
Remove the tapered cone ring, distance collar, synchro ring and 5th synchro sleeve.
|
|
-
Support 5th gear (A) on steel blocks, and press the mainshaft out of the 5th synchro hub (B).
NOTE: Do not use a jaw-type puller; it can damage the gear teeth.
|
|
-
Support the 3rd gear (A) on steel blocks, and press the mainshaft out of the 3rd/4th synchro hub (B).
NOTE: Do not use a jaw-type puller; it can damage the gear teeth.
|
|