( TF09E60K796000919F2FAAT00 )
DTC Troubleshooting: P19F2 (152-23)
DTC P19F2:
 Shift Actuator Motor Rotating Direction Sensor Signal Circuit High Voltage
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Turn the ignition switch to LOCK (0).
  1. Turn the ignition switch to ON (II).
  1. Check for DTCs with the HDS.
Is DTC P19F2 indicated?
YES -
Go to Step 6 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the shift actuator motor 6P connector.
  1. Connect shift actuator motor 6P connector terminal No. 4 and body ground with a jumper wire.
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Turn the ignition switch to LOCK (0).
  1. Turn the ignition switch to ON (II).
  1. Check for DTCs with the HDS.
Is DTC P19F2 indicated?
YES -
Repair an open in the wire between the TCM (B8) and the shift actuator motor.■
NO -
Go to Step 14 .
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the TCM connector B (40P).
  1. Turn the ignition switch to ON (II).
  1. Measure voltage between shift actuator motor 6P connector terminal No. 4 and body ground.
Is there battery voltage?
YES -
Repair a short to power in the wire of the change actuator subharness A.■
NO -