( TF09E60K796000919EDFAAT00 )
DTC Troubleshooting: P19ED (150-22)
DTC P19ED:
 Shift Actuator Motor Rotating Pulse/Rotating Direction Sensor Supply Signal Circuit High Voltage
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Turn the ignition switch to LOCK (0).
  1. Turn the ignition switch to ON (II).
  1. Check for DTCs with the HDS.
Is DTC P19ED indicated?
YES -
Go to Step 6 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the shift actuator motor 6P connector.
  1. Connect the shift actuator motor 6P connector terminal No. 3 and body ground with a jumper wire.
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Turn the ignition switch to LOCK (0).
  1. Turn the ignition switch to ON (II).
  1. Check for DTCs with the HDS.
Is DTC P19ED indicated?
YES -
Repair an open in the wire between the TCM (B20) and the shift actuator motor.■
NO -
Replace the transmission shift change actuator. (A few DTCs related with open circuit will be stored at this time.)■