|
DTC P19E7:
Clutch Contact Position 3 Learning Not Completed
NOTE: If the Clutch Contact Position 3 Learning is incomplete after replacing the clutch disc, repeat the Clutch Contact Position 3 Learning several times. If the Clutch Contact Position 3 Learning is still incomplete, check the clutch disc installation.
-
Turn the ignition switch to ON (II).
-
Clear the DTCs with the HDS.
-
Start the engine. Hold the engine speed at 3,000 rpm (min
−1
) without load until the radiator fan comes on, then let it idle.
-
Turn the headlight switch to ON.
-
-
Check for DTCs with the HDS.
|
YES
|
-
|
|
|
NO
|
-
|
Intermittent failure, the system is OK at this time.■
|
-
Turn the ignition switch to LOCK (0).
-
-
-
Check for DTCs with the HDS.
|
YES
|
-
|
Go to
Step 8
and repeat the steps.
|
|
NO
|
-
|
Clutch Contact Position 3 Learning is complete.■
|
|