( TF09E60K796000919E6FAAT00 )
DTC Troubleshooting: P19E6 (164-1)
DTC P19E6:
 Clutch Temperature Too High (Over 300 °C (572 °F))
NOTE:
  • DTC P19E6 is stored when the clutch temperature is higher than 300 °C (572 °F).
  • If the DTC P19E6 is stored, the system stops the creep control.
  • The value of the clutch temperature is reset when the DTC is cleared with the HDS.
  • The clutch temperature is high when the UP/DOWN operation is done frequently at a short time.
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Test-drive the vehicle for at least 10 minutes.
  1. Check for DTCs with the HDS.
Is DTC P19E6 indicated?
YES -
Go to Step 5 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Check for DTCs with the HDS.
Is DTC P19E6 indicated?
YES -
Update the TCM if it does not have the latest software, or substitute a known-good TCM, then recheck. If the symptom/indication goes away with a known-good TCM, replace the original TCM. ■
NO -
The system is OK at this time (Failure by air in the fluid).■