DTC P0882:
TCM Power Input Voltage Lower than ECM Power Input Signal
NOTE: Before troubleshooting, check for Fuel and Emissions systems DTCs. If any DTCs are indicated, troubleshoot the indicated DTCs first.
-
Turn the ignition switch to ON (II).
-
Clear the DTCs with the HDS.
-
Turn the ignition switch to LOCK (0).
-
Turn the ignition switch to ON (II), and wait for at least 1 second.
-
Turn the ignition switch to START (III).
-
Check for DTCs with the HDS.
YES
|
-
|
|
NO
|
-
|
Intermittent failure, the system is OK at this time.■
|
-
Turn the ignition switch to LOCK (0).
-
Disconnect the clutch actuator subharness 10P connector.
-
Turn the ignition switch to ON (II).
-
Measure voltage between clutch actuator subharness 10P connector terminal No. 2 and body ground.
Is there battery voltage?
|
-
Check the No. 12 (10 A) fuse in the under-dash fuse/relay box.
YES
|
-
|
Repair an open in the wire between the No. 12 (10 A) fuse in the under-dash fuse/relay box and the clutch actuator subharness 10P connector.■
|
NO
|
-
|
|
-
Remove the No. 12 (10 A) fuse from the under-dash fuse/relay box.
|