( TF09E60K79600090810FAAT00 )
DTC Troubleshooting: P0810 (163-3)
DTC P0810:
 Clutch Operation Problem
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Do the CLUTCH ACTUATOR FULL STROKE OPERATION in the FUNCTIONAL TEST MENU with the HDS.
  1. Turn the ignition switch to LOCK (0).
  1. Turn the ignition switch to ON (II).
  1. Check for DTCs with the HDS.
Is DTC P0810 indicated?
YES -
Go to Step 7 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Check the clutch hose and pipe between the slave cylinder and the TCM if they are twisted or cracked.
Are they OK?
YES -
Go to Step 9 .
NO -
Replace the damaged hose or pipe.■
  1. Turn the ignition switch to ON (II).
  1. Check for DTCs with the HDS.
Is DTC P0810 indicated?
YES -
Update the TCM if it does not have the latest software, or substitute a known-good TCM, then recheck. If the symptom/indication goes away with a known-good TCM, replace the original TCM. ■
NO -
Check for these conditions, and repair if necessary:■
  • Slave cylinder
  • Release syatem