Exploded View
Special Tools Required
Inner driver handle, 40 mm
07746-0030100
Inner bearing driver attachment, 30 mm
07746-0030300
NOTE: Refer to the Exploded View as needed during this procedure.
-
Clean all the parts in solvent, dry them, and apply lubricant to all contact surfaces except the 3rd/4th and 5th synchro hubs.
-
Install the needle bearing and 3rd gear on the mainshaft.
-
Install the 3rd gear synchro ring and synchro spring on the shaft.
-
Install the 3rd/4th synchro hub (A) by aligning the synchro cone fingers (B) with the grooves in 3rd/4th synchro hub (C).
-
Install the 3rd/4th synchro hub using the special tool.
|