( TF09E60E3415033911EMAAT00 )
M/T Reverse Shift Fork Clearance Inspection

  1. Measure the clearance between the reverse idler gear (A) and the reverse shift fork (B) with a feeler gauge (C). If the clearance is more than the service limit, go to Step 2 .
    Standard:
    0.20−0.60 mm (0.007−0.024 in.)
    Service Limit:
    1.2 mm (0.047 in.)


  1. Measure the width of the reverse shift fork.
    • If distance is not within the standard, replace the reverse shift fork.
    • If distance is within the standard, replace the reverse gear.
    Standard:
    14.7−14.9 mm (0.527−0.587 in.)