Use the special tool to bottom the differential assembly in the clutch housing.
Measure clearance between 80 mm shim and bearing outer race in transmission housing.
Standard:
0.01−0.10 mm (0.0004−0.0039 in.)
If the clearance is more than the standard, select a new shim from the following table. If the clearance measured in step 5 is within the standard, go to
Step 9
.
80 mm Shim
Type
Part Number
Thickness
A
41441-PL3-B00
1.00 mm (0.039 in.)
B
41442-PL3-B00
1.10 mm (0.043 in.)
C
41443-PL3-B00
1.20 mm (0.047 in.)
D
41444-PL3-B00
1.30 mm (0.051 in.)
E
41445-PL3-B00
1.40 mm (0.055 in.)
F
41446-PL3-B00
1.50 mm (0.059 in.)
G
41447-PL3-B00
1.60 mm (0.063 in.)
H
41448-PL3-B00
1.70 mm (0.067 in.)
J
41449-PL3-B00
1.80 mm (0.071 in.)
K
41450-PL3-B00
1.05 mm (0.041 in.)
L
41451-PL3-B00
1.15 mm (0.045 in.)
M
41452-PL3-B00
1.25 mm (0.049 in.)
N
41453-PL3-B00
1.35 mm (0.053 in.)
P
41454-PL3-B00
1.45 mm (0.057 in.)
Q
41455-PL3-B00
1.55 mm (0.061 in.)
R
41456-PL3-B00
1.65 mm (0.065 in.)
S
41457-PL3-B00
1.75 mm (0.069 in.)
Remove the bolts and transmission housing.
Replace the thrust shim selected in step 6, then recheck the clearance.