Paddle Shifter + (Upshift Switch) Replacement
SRS components are located in this area.
Review the SRS component locations
and
the precautions and procedures
before doing repairs or service.
Remove the steering wheel.
Remove the four screws (A) securing the steering wheel rear cover (B), then remove the steering wheel rear cover.
Remove the paddle shifter + (upshift switch) connector (A) from its holder, and disconnect the connector.
Remove the screws (B) securing the paddle shifter + (C), remove the paddle shifter +, and replace it with a new one.
Install the new paddle shifter + on the steering wheel, and secure it with the screws.
Connect the paddle shifter + connector securely, and install the connector in the connector holder.
Install the steering wheel rear cover, and secure the rear cover with the four screws.
Install the steering wheel.