i-SHIFT Clutch Actuator/TCM Removal/Installation
NOTE:
-
-
-
-
Remove the battery harness clamps (A), then release the lock and remove the clutch actuator connector (B).
-
Remove the battery base bolts (C) and the reservoir tube (D), then remove the battery base (E).
|
|
-
Remove the bolts (A) from the slave cylinder (B) so as not to bend the clutch line.
|
|
-
Remove the clutch reservoir tank (A) from the bulkhead (B).
NOTE:
-
Do not spill brake fluid from the reservoir tank.
-
When remove the reservoir tank, fix the reservoir tank by hand.
|
|
-
Disconnect the clutch actuator connector (A) and the ground cable (B).
|
|
-
Release the lock and remove the transmission shift change actuator connector (A), then remove the transmission shift change actuator harness cover (B) and the harness clip (C).
|
|
-
Disconnect the transmission shift change actuator connector (A).
-
Raise the vehicle, and make sure it is securely supported.
-
|
|
-
Loosen the bolts (A), then remove the clutch actuator (B) with the clutch pipe comp (C) and the clutch fluid tube assembly (D).
-
Install the clutch actuator in the reverse order of removal.
-
-
-
-
Test-drive the vehicle.
|
|