Non-creep
NOTE: The creep function is only supported in gears, 1, 2, and R.
-
Turn the ignition switch to ON (II).
-
Check these parameters in the DATA LIST with the HDS (check signal change inactive/active):
Do they show the proper valve?
|
YES
|
-
|
|
NO
|
-
|
Repair the items that did not show the proper valve.■
|
-
Press the brake pedal, and change the shift lever to the A/M position.
-
Compare the TARGET GEAR and the ACTUAL GEAR in the DATA LIST with the HDS.
-
Is the i-SHIFT system learning OK?
|
-
Test-drive, under these conditions:
NOTE: During test drive, read out the actual clutch temperature with the HDS. Do not start test drive with clutch temperature of 100 °C.
-
Clear any DTCs with the HDS.
-
Check the creep condition.
YES
|
-
|
Vehicle is normal.■
|
NO
|
-
|
|
|