No Transmission Power to Wheels
-
Start the engine.
-
Press the brake pedal, and change the shift lever to the A/M position.
-
Check the BRAKE SWITCH in the DATA LIST with the HDS.
-
Check that the gear position indicator is displayed in 1st gear while in Auto mode.
NOTE: When all the doors are closed, the gear position indicator should not flash. If the gear position indicator flashes, go to
Step 5
.
Is the gear position displayed?
|
-
Check for these conditions:
-
Leaks at hoses and line joints and connections, and repair if necessary.
-
Clutch lines for damage and leaks. Also check for bent clutch lines.
-
Reservoir level.
YES
|
-
|
|
NO
|
-
|
Repair the problems, then go through
Step 1
to 4 and make sure it is normal.■
|
-
-
Check that the gear position indicator is displayed in 1st gear while in Auto mode.
Is the 1st gear position displayed?
|
-
Read out error memory and remove errors if present.
-
Check the clutch, concentric slave cylinder.
YES
|
-
|
|
NO
|
-
|
Repair the problems, then go through
Step 1
to 4 and make sure it is normal.■
|
-
Do the ENGAGE GEARS in the FUNCTIONAL TEST MENU with the HDS, and try to shift the position that cannot be shifted.
Does the actuator move normally?
|
YES
|
-
|
|
NO
|
-
|
Repair the transmission internal failure, then go through
Step 1
to 4 and make sure it is normal.■
|
|