Engine Doesn't Crank
-
Turn the ignition switch to ON (II).
-
Press the brake pedal, and change the shift lever to the N position.
-
Check the MECHANICAL GEAR STACK FOR STARTER ENABLE in the DATA LIST with the HDS.
Is the starter enable signal OK?
|
-
Check the FOOTBRAKE ON SIGNAL FOR STARTER ENABLE in the DATA LIST with the HDS.
Is the starter enable signal OK?
|
-
Check the CLUTCH OPEN SIGNAL FOR STARTER ENABLE in the DATA LIST with the HDS.
Is the starter enable signal OK?
|
-
Check the CLUTCH POSITION in the DATA LIST with the HDS.
Is there more 15 mm (0.6 in.)?
|
YES
|
-
|
Check for these conditions, and repair if necessary:■
|
NO
|
-
|
Check for these conditions, and repair if necessary:■
-
Slave cylinder
-
Release fork
|
-
Check the NEUTRAL SHIFTER SIGNAL FOR STARTER ENABLE in the DATA LIST with the HDS.
Is the starter enable OK?
|
-
Move the shift lever in N, then check the SHIFT VALID N FROM SHIFTER in the DATA LIST with the HDS.
-
Check the ENGAGE GEAR NEUTRAL in the DATA LIST with the HDS.
Does the gear change into the N position?
|
YES
|
-
|
|
NO
|
-
|
Repair the transmission internal failure.■
|
-
-
Try to start the engine.
YES
|
-
|
Troubleshooting is complete.■
|
NO
|
-
|
|
|
|