|
Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers if the throttle valve is activated.
|
-
-
Remove the harness clamp (A).
-
Disconnect the throttle body connector (B), and the EVAP canister purge valve connector (C).
-
Disconnect and plug the water bypass hoses (D), the purge hose (E).
-
Remove the throttle body (F).
-
Remove the purge pipe (G), the water bypass hoses, and the purge hose from the throttle body.
-
NOTE:
-
If you replace or clean the throttle body, go to
Step 8
.
-
If you did not replace or clean the throttle body, this procedure is complete.
-
Be careful not to damage to drops the plates (I).
-
Align the marks (J) on the hose and throttle body, then insert the hose. Make sure the clamp (K) is positioned as shown.
-
Align the mark (L) on the hose as shown, then insert the hose. Make sure the clamp (M) is positioned as shown.
|
|