Intake Manifold Chamber Removal and Installation
Exploded View
Removal
-
-
-
Remove the engine wire harness connectors and wire harness clamps from the intake manifold chamber.
-
Remove the brake booster vacuum hose (A) and the harness clamp (B).
-
Remove the water bypass hose from the clamp (C).
|
|
-
Remove the throttle body without disconnecting the water bypass hoses.
|
|
-
Remove the intake manifold bracket mounting bolts.
|
|
-
Remove the intake manifold chamber.
|
|
Installation
-
Install the intake manifold chamber (A) with a new gaskets (B), and tighten the bolts in a crisscross pattern in three steps, beginning with the inner bolt.
|
|
-
Loosen the intake manifold bracket mounting bolt (A). Tighten the mounting bolts (B), then tighten the mounting bolt (A).
|
|
-
Install the throttle body (A) with a new gasket (B).
|
|
-
Install the water bypass hose to the clamp (A).
-
Install the brake booster vacuum hose (B) and the harness clamp (C).
-
Install the engine wire harness connectors and wire harness clamps to the intake manifold chamber.
-
-
|
|