Intake Manifold Removal and Installation
Exploded View
Removal
-
Remove the harness holder mounting bolt, then remove the harness holder (A) from the bracket.
-
Remove the positive crankcase ventilation (PCV) hose (B).
-
Disconnect the exhaust gas recirculation (EGR) valve connector.
-
Remove the dipstick.
-
Remove the intake manifold.
-
Remove the intake manifold bracket C.
|
|
Installation
-
-
Install the intake manifold bracket C (B).
-
Install the intake manifold (C) with new gaskets (D), and tighten the bolts and nuts in a crisscross pattern in three steps, beginning with the inner bolt.
-
Install the dipstick.
-
Connect the EGR valve connector.
|
|
-
Install the PCV hose (A) and harness holder (B).
|
|