NOTE:
-
Disconnect the evaporative emission (EVAP) canister purge valve connector.
-
Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard, or a tachometer (B) to the test tachometer connector (C).
-
When using the HDS, make sure the HDS communicates with the ECM/PCM. If it doesn't, go to the DLC circuit troubleshooting.
-
Start the engine. Hold the engine speed at 3,000 rpm (min
−1
) without load (A/T in P or N, M/T in neutral) until the radiator fan comes on, then let it idle.
-
Check the idle speed without load conditions: headlights, blower fan, radiator fan, and air conditioner off.
L13Z3 engine
M/T
|
700±50 rpm (min
−1
)
|
A/T
|
700±50 rpm (min
−1
) (in N or P)
|
L15A8 engine
M/T
|
700±50 rpm (min
−1
)
|
A/T
|
700±50 rpm (min
−1
) (in N or P)
|
-
Let the engine idle for 1 minute with high electric load (A/C switch on, temperature set to max cool, blower fan on High, and headlights on high beam).
M/T
|
790±50 rpm (min
−1
)
|
A/T
|
790±50 rpm (min
−1
) (in N or P)
|
-
Reconnect the EVAP canister purge valve connector.
|
|