-
Coat the new O-rings (black) (A) with clean engine oil, and insert the injectors (B) into the fuel rail (C).
-
Install the injector clips (D).
-
Coat the new injector O-rings (brown) (E) with clean engine oil.
-
Install the fuel rail and the injectors in the cylinder head (F).
-
Install the fuel rail mounting nuts (G).
-
Connect the injector connectors (H).
-
Connect the quick-connect fitting (I).
-
Turn the ignition switch to ON (II), but do not operate the starter. After the fuel pump runs for about 2 seconds, the fuel rail will be pressurized. Repeat this two or three times, then check for fuel leakage.
-
|
|