Special Tools Required
Fuel sender wrench, clysler fuel pump module wrench
No. 7998
, or equivalent, commercially available
-
-
Set the fuel subtank (A) to the vice.
-
Using the tool, loosen the locknut (B). Remove the subfuel pump (C).
-
Install the parts in the reverse order of removal with a new gasket (D) and locknut plate (E).
NOTE:
-
Align the marks (F) on the fuel tank and the fuel tank unit, then tighten a new locknut by hand.
-
After installation and tightening, check the base gasket visually or by hand to be sure the gasket is not pinched.
-
Do not coat the base gasket with engine oil.
|
|