NOTE:
-
This procedure checks the APP sensor in this fully closed position. In any other position, the APP sensor stores DTCs which are covered in other troubleshooting procedures.
-
Check for Temporary DTCs or DTCs with the HDS before doing this procedure. If any DTCs are indicated, troubleshoot them first, then do this procedure.
-
-
Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
-
Turn the ignition switch to ON (II).
-
-
Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.
-
Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.
|
|