( TF09E1PK77100090747FAAT00 )
DTC Troubleshooting: P0747 (76)
DTC P0747:
 A/T Clutch Pressure Control Solenoid Valve A Stuck ON
NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot with the HDS, and review General Troubleshooting Information.
  1. Warm up the engine to normal operating temperature (the radiator fan comes on).
  1. Make sure that the transmission is filled to the proper level, and check for fluid leaks.
  1. Drain the ATF through a strainer. Inspect the strainer for metal debris or excessive clutch material.
Does the strainer have metal debris or excessive clutch material?
YES -
Replace the transmission, then go to Step 10 .
NO -
  1. Clear the DTC with the HDS.
  1. Test-drive the vehicle with the shift lever in D for at least 12 seconds, and let the transmission shift through all five gears. Then slow down to a stop.
  1. Monitor the OBD status for P0747 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the HDS indicate FAILED?
YES -
Go to Step 7 .
NO -
Intermittent failure, the system is OK at this time. If the HDS indicates NOT COMPLETED, return to Step 5 and recheck.
  1. Clear the DTC with the HDS.
  1. Select Clutch Pressure Control (Linear) Solenoid Valve A in the Miscellaneous Test Menu, and test A/T clutch pressure control solenoid valve A with the HDS.
Does the HDS indicate NORMAL?
YES -
Intermittent failure, the system is OK at this time.■
NO -
Follow the instructions indicated on the HDS by the test result, but if the HDS has not determined the cause of the failure, go to Step 9 . If any part is replaced, go to Step 10 .
Does A/T clutch pressure control solenoid valve A work properly?
YES -
Repair the hydraulic system related with shift valve A, or replace the transmission, then go to Step 10 .
NO -
  1. Clear the DTC with the HDS.
  1. Test-drive the vehicle with the shift lever in D for at least 12 seconds, and let the transmission shift through all five gears. Then slow down to a stop.
  1. Monitor the OBD status for P0747 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the HDS indicate PASSED?
YES -
Troubleshooting is complete.■
NO -
Return to Step 10 and recheck. If the HDS indicates NOT COMPLETED, return to Step 11 and recheck.