Special Tools Required
Driver handle 15 x 135L
07749-0010000
Driver attachment, 72 x 75 mm
07746-0010600
Diff preload inspection attachment
07HAJ-PK40201
NOTE: If the transmission housing, torque converter housing, differential carrier, tapered roller bearing, bearing outer race, or thrust shim were replaced, the bearing preload must be adjusted.
-
Remove the bearing outer race (A), 76.2 mm spacer (B), and 76 mm thrust shim (C) from the transmission housing (D) by heating the housing to about 100 °C (212 °F) with a heat gun (E). Do not heat the housing more than 100 °C (212 °F).
NOTE: Let the transmission housing cool to room temperature before adjusting the bearing preload.
-
Replace the tapered roller bearing when the outer race is to be replaced.
-
Do not use a shim on the torque converter housing side.
|