-
Inspect the thrust needle bearing and the needle bearing for galling and rough movement.
-
Inspect the splines for excessive wear and damage.
-
Check the shaft bearing surface for scoring and excessive wear.
-
Before installing the O-rings, wrap the shaft splines with tape to prevent O-ring damage.
-
Lubricate all parts with ATF during assembly.
-
Install the conical spring washer, idler gear, and 31 x 50 mm thrust washer in the direction shown.
-
Replace the locknut and conical spring washer with new ones when assembling the transmission. The locknut has left-hand threads.
-
-
Inspect the condition of the sealing rings. If the sealing rings are worn, distorted, or damaged,
replace them.
|
|